Magnum MMG75D Manual do Operador descarregar pdf (Página 22)

GENERATOR SCREEN

The Generator screen displays the average voltage frequency, volts and amps from the generator, as well as line-

to-line voltage, and individual line-to-neutral voltage, amperage and power (kW). This screen also displays the current

voltage selector switch current setting.

Note: When loading the generator, it is important to observe the amperage to determine the load balance on each

line of the generator. Minor load unbalances, usually ten percent or less, will not cause any particular problems.

Every effort should be made to distribute the load equally between all lines.

• Freq: Displays the output frequency in Hertz (Hz). Normal operating frequency is 60 Hz.

• Volts: Displays the nominal voltage in Volts (V).

• Amps: Displays the AC output amperage produced by the generator in Amps (A).

Additional information can be found on the electric power table at the bottom-left side of the screen. This provides

an overview of all three lines and average voltage and amperage readouts.

GENERATOR TAB - MAINTENANCE SCREENS

Additional generator information can be viewed on the Maintenance screens by pressing the left or right arrow and

highlighting the “Generator” tab. Refer to “Maintenance Screens” on page 18 for more information.

ENGINE MONITORING

Engine information is displayed on both the Engine screen and “Engine” tab within the Maintenance screens.

ENGINE OPERATOR SCREEN

The Engine Operator screen displays the oil pressure, coolant temperature and battery voltage from the engine on

the three main gauges. Total run time is displayed below the three main gauges on the hour meter and the maintenance

configuration status at the bottom of the screen.

The maintenance configuration status displays upcoming maintenance procedures in black text, and past due

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 51 52

Sem comentários

Magnum MMG75D Manual do Operador Página 22